alyons@arb.ca.gov wrote:
Paul, I don't know all the details of your situation,
but if you got a misfire code and
you're pretty sure the plug wires took care of it, the MIL should
extinguish soon. In any event, you don't have to go to the dealer.
Most independent shops should have a scan tool that can read and
erase codes. I can't imagine anyone charging much (if anything) for
a code clearing, since it takes about 30 seconds. If the misfire is
gone, the MIL should not re-illuminate. I understand your point
about reading fault codes without a scan tool. It was that way with
OBD I, and we did not get the impression that the average consumer
got any use out of it. Maybe we can look into it again, but it would
help for future model year vehicles.
Allen.
The light still did not go off.
I just this minute got off the phone with John Grable of Car
Comp. I ordered his $300 Ford OBD II PC software. John told
me about innumerable violations in the OBD II specifications by
Ford. For all I know I have an early OBD II car with many bugs
in the engine computer software. I encouraged John to write this
stuff up and email it to you.
http://www.carcomp.com
So far I have yet to find an independent shop with an OBD II
Ford scan tool. According to the Ford service manager at Galpin
Ford the tool cost $20,000. I don't think many shops can charge
much less than Ford and still pay for that tool.
Do you know of any Ford OBD II tools other than Car Comp
software and a PC ($1300-$2300) that cost less than $20,000?
So far Car Comp has sold less than 100 Ford software packages.
If so, how much do they really cost? Do you also have a list of
independent shops in Southern CA that have such tools?
You should be promoting them to pay penances for your
past sins on this OBD II matter :-)
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org