Rogers, Bob J. wrote:
Earlier discussions raised the possibility that two-cycle oil might be used
in the crankcase of the rotary engine, so that the oil injected into the
rotary chamber to lubricate the apex seals would not cause so much
contamination when it burned. I was intrigued with this idea, because it
would allow the use of the stock oil metering system and prevent having to
manually measure and mix two-cycle oil into the fuel tank every time fuel is
added. I have been uncomfortable with the idea of adding two-cycle oil to
the fuel for a number of reasons, such as: I am not sure I would get an
even distribution of oil in the fuel, the engine needs different levels of
oil in the combustion chamber at different loads and speeds, and it is a
hassle to have to carry extra oil around and measure and pour it every time
fuel is added. (What happens if the fuel truck adds fuel when you are not
at the airplane to pour in the oil first to get a good mix?)
My local EAA chapter met last night and as our guest speaker, we had Mr. Jim
Sico, who is a lubrication engineer for Chevron here in Dallas. He is also
an aeronautical engineer, a chemical engineer, an A&P and a pilot. He
previously did research for Gulf Oil in the development of gasoline engine
lubricants. I privately asked him what he thought about the idea of using
two cycle oil in the crankcase of a mazda rotary engine. He said that the
oil would not be appropriate because it did not have the necessary additives or
viscosity stability to do the job.
He said that there are a number of additives in needed in modern engine oils
that two-cycle oil either does not have or does not have in the proper
amounts. A good quality engine oil has a carefully engineered balance of
things other than the base lubricant. Included are various additives, such
as anti-wear agents, extreme pressure additives, anti-rust agents, corrosion
inhibitors, detergents, dispersants, and friction modifiers. Also included
are various oil modifiers, such as pour point depressants, viscosity index
improvers, and seal swell agents. Finally, an oil company may add various
compounds that help protect the base stock, such as anti-foam agents,
antioxidants, and metal deactivators.
There are excellent discussions of engine oils at
http://www.geocities.com/MotorCity/2195/engineoil_bible.html and
http://www.vtr.org/maintain/oil-synthetics.html
I guess that now I am back to the idea that I will just add two-cycle oil to
the fuel. One ounce per gallon sounds like it would be more than enough to
meet even the highest loads and still not cause detonation or plug fouling.
What do you think?
Paul Lamar
I think you are missing a major point here. Since load is proportional
to GPH fuel burned... the oil in the fuel is automatically increased
with load. I also think you could err on the side of two or three
ounces per gallon and not get plug fouling.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org