Alan Tolle wrote:
I recently wrote that the best qualified person to address the question of
using 2 cycle oil in the crankcase of the 13B would be a petroleum engineer.
Thanks to Bob Rogers for his question to just such an individual. I read
the answer to be no, which should end the discussion. If we still want to
talk about oil, consider whether the oil that is appropriate for the engine
is equally appropriate for the gear box. This is a hot discussion among the
Stewart S-51 pilots/builders today (the answer appears to be no), and one
that had Everett Hatch concerned regarding the rotary. Automotive automatic
transmission planetary gears normally do not live their lives in crankcase
oil.
BTW something was mentioned about what happens if your aircraft is refueled
in your absence and you didn't mix in the 2 cycle oil? Shouldn't ever
happen! One of the cardinal rules of the careful aviator is that nothing is
ever done to my aircraft in my absence. Period. That includes first of
all fueling.
There has been some discussion about vents on the top side of the cowling
forward of the windscreen. The Powersport RV-4 recently pictured on these
pages showed such a vent. That vent was for the outlet air from the oil
cooler. There was an aft tilted lip before the vent to produce negative
pressure. The oil cooler was mounted horizontally near the top of the cowl,
just forward of the top of the water radiator. Air entered it from the cold
air pressure plenum below. The opening in the cowl above the cooler was
sized by trial and error so that the oil and water temps stay the same with
the opening and closing or the cowl flap. As I have said here before, if I
were building any RV series aircraft today I would copy that cooling system
from the RV-4 because it worked well both to cool and heat the engine in all
realms of flight operation.
Tracy has recently noted that even after 800 flight hours his engine
installation runs too cool at altitude on cruise. It obviously has to if it
is going to cool enough in climb on a hot day. Yes, you need a cowl flap.
You will be really amazed what closing the cowl flap at altitude on cruise
will do for your airspeed. This is really the key to all of that rotary
engine cooling drag reduction that we have been talking about. The speed
comes from being able to decrease the air flow through the cowl (hence
decrease the drag) by closing the cowl flap at altitude cruise power
settings.
Anyway, I have experienced oil on the windshield in flight from Lycoming,
Continental, and yes, from the rotary engine. All were from the front
crankshaft seal. (The blobs of grease are different and come from the
constant speed propeller blade seal.) Frankly, if I have an engine oil leak
I want to know about it so that I can land and at least assess the potential
danger from same. ( I have flown a lot of hours with engine oil leaks
which, once assessed, posed no problem at all. ) I consider oil on the
windshield as, again, the engine trying to tell me something. Those cases
where oil covers and obscures the windshield are not warnings but are
catastrophic failures and it usually makes no difference where the vents are
located.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org