Tracy Crook wrote:
I think the confusion is caused by the "static timing" that Ed mentioned
earlier. This is set by positioning the engine at 30 Degrees BTDC on rotor
one and then adjusting the crank angle sensor (CAS) so that the top trigger
wheel (with two points on it) is lined up with the pickup. This is the
signal timing to the ECU, NOT the timing of the spark. The engine will
run at this setting but the CAS should later be adjusted to give 20 - 23
degrees of spark advance at 5000 RPM (using a timing light). 18 - 20
degrees will give max HP at SL but a bit more advance will help at low
throttle & high altitude. I found that in general the rotary is not nearly
as sensitive to timing advance as most recips.
I don't have anything to add to the sparkplug heat range discussion. I use
the BUR-7EQ (leading) and BUR-9EQ (trailing) plugs that Mazda recommends.
I've used up 3 sets in 800+ hours of flight. No complaints.
Tracy Crook
rws@altavista.net
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org