Cz2002@aol.com wrote:
Paul, I wonder if this is a fair test if you are cooking the oil at 500 deg.
Because our exhaust temps would run between 1400 & 1500 and after 55 or so
laps we would tear them down & the combustion chamber & plug were still
spotless. We kept a close record of CHT&EGT and we never had any carbon build
up. I can't remember the CHTs off the top of my head but I can look them up
for you if you would like. Jim Lentine
Jim, I am going on what Mazda says is the apex seal temp. Here it is
out of one of thier SAE tech papers on the subject. Perhaps
piston engine compression rings do not see these kinds of temps.
240 C is 464 degrees F
Apex seal springs start to relax at these temps.
BTW coking inside the rotor and on the rotor housing inner
surface is a possibility so I would use synthetic 20-50
engine oil as system oil as well as two cycle oil in the gas.
In my test, Havoline synthetic was almost as good as two cycle
oil. Havoline was the only brand I tested. I have seen ads
on TV of Mobil 1 being cooked at high temp.
BTW I suspect that precipated material in the Klotz test was
powdered teflon in suspension. I could be way wrong.
Just a wild ass guess. The red color probably comes from a
dye which does not help.
Also BTW no sign of deterioration in the Mazda o-ring soaking in
turbine oil so far.
Paul Lamar apextemp.jpg
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org