Neil A. Kruiswyk wrote:
Paul,
Now I think you're starting to catch on, however, my firewall to flange
is no longer than any other installation. In fact, if memory serves.. I'm
35". I know for a fact that there is only 2" between the excentric shaft
pulley and the firewall because that's the size of the spacer I used when I
built the motor mount. I'm actually a little shorter than a standard
Lancair 235 and I did this because of weight and balance. The O-235 called
for in the plans is lighter than the 13B so I wanted it as close to the
firewall as I could possibly get it and still service the waterpump.
I changed the shape of the cowl to remove the nacelles to reduce the
drag when I went to a belly scoop. This was no small feat but I believe it
was worth the effort. The same could be done on an RV-6 because without the
rads up front, there is a ton of wasted space (and wasted drag). Again,
it's a fair bit of fiberglass work which, from experience, the aluminum guys
hate with a passion. (All in a days work for me.) Tracy freely admits his
cowl is less than pretty. Alan's RV-3 had a hand hammered aluminum cowl!!,
no cheeks, very little drag.
The big question for me is... Will my new belly scoop and streamlined
cowl have more overall drag than a standard RV-6 or the original Lancair
235? Probably near the same amount.
Neil
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org