Subject: Engine weight, cooling, FAA Endurance FAR
From: Paul
Date: 3/16/1999, 9:07 AM
To: zz

Peter Cowan/Lexi Cameron wrote:

Allan, I believe you have confirmed what I suggested could be the only
reason for your concern about length of prsu: that the GIVEN in your
environment is the position of the the prop; that the cowl and nose bowl
must be stock.  Again, not everyone has that constraint.  No one is arguing
about getting the right CofG.

Am I truly off base if I am willing to accept a limitation on duration of
full power?  Do I really have to design for  100% power for  extended
periods?  Weren't there factory products that had 5 min limits on full
power? I personally do only need 200hp for 20seconds. In my last 20 years
with the 0360 I can't recall any instance of  needing it at sea level for
longer than that.

Out here in the West we have a different perspective. We are frequently 
confronted with 14,000 foot mountains and head winds. I know the power
is way down but climbing from sea level to go through some high passes
against a head wind at gross weight you need all the power the engine 
can put out given the altitude and for at least 30 minutes maybe more. 
We are talking 75% to 90% max power depending on altitude of course. 
I know it is not 100% at sea level but why quibble over 10% or so.
You may need it in the East to climb over weather some day.

You want the engine to be at least as good as a certified engine:

FAR 33.49 Endururance test.

(a) GeneraL Each engine must be subjected to an endurance test that 
includes a total of 150 hours of operation (except as provided 
in paragraph (e)(1)(iii) of this section) and, depending upon the 
type and contemplated use of the engine, consists of one of the 
series of runs specified in paragraphs (b) through (e) of this 
section, as applicable. The runs must be made in the order found 
appropriate by the Administrator  for  the  particular engine 
being tested. 

During the endurance test the engine power and the crankshaft 
rotational speed must be kept within +/- 3 percent of the rated 
values. During the runs at rated take-off power and for at least 35 
hours at rated maximum continuous power, one cylinder must be 
operated at not less than the limiting temperature, the other 
cylinders must be operated at a temperature not lower than 50 
degrees F. below the limiting temperature, and the oil inlet 
temperature must be maintained within +/- 10 degrees F. of the 
limiting temperature. An engine that is equipped with a propeller 
shaft must be fitted for the endurance test with a propeller that 
thrust-loads the engine to the maximum thrust which the engine is 
designed to resist at each applicable operating condition specified 
in this section. Each accessory drive and mounting attachment must 
be loaded. During operation at rated takeoff power and rated maximum 
continuous power, the load imposed by each accessory used only for 
an aircraft service must be the limit load specified by the 
applicant for the engine drive or attachment point. 

(b) Unsupercharged engines and engines  incorporating  a  
gear-driven single-speed supercharger. For engines not incorporating 
a supercharger and for engines incorporating a gear-driven 
single-speed supercharger the applicant must conduct the following 
runs: 

(1) A  30-hour run consisting of alternate periods of 5 minutes at 
rated takeoff power with takeoff speed, and 5 minutes at maximum 
best economy cruising power or maximum remmended cruising power.

(2) A 20-hour run consisting of alternate periods of 1 1/2 hours at 
rated maximum continuous power with maximum continuous speed, and 
1/2 hour at 75 percent rated maximum continuous power and 91 percent 
maximum continuous speed.

(3) A 20-hour run consisting of alternate periods of 1 1/2 hours at 
rated maximum continuous power with maximum continuous speed, and 
1/2 hour at 70 percent rated maximum continuous power and 89 percent 
maximum continuous speed.

(4) A 20-hour run consisting of alternate periods of 1 1/2 hours at 
rated maximum continuous power with maximum continuous speed, and 
1/2 hour at 65 percent rated maximum continuous power and 87 percent 
maximum continuous speed.

(5) A 20-hour run consisting of alternate periods of 1 1/2 hours at 
rated maximum continuous power with maximum continuous speed, and 
1/2 hour at 60 percent rated maximum continuous power and 84.5 
percent maximum continuous speed.

(6) A 20-hour run consisting of alternate periods of 1 1/2 hours at 
rated maximum continuous power with maximum continuous speed, and 
1/2 hour at 50 percent rated maximum continuous power and 79.5 
percent maximum continuous speed.

(7) A 20-hour run consisting of alternate periods of 2 ½ hours at 
rated maximum continuous power with maximum continuous speed, and 
2 1/2 hours at maximum best economy cruising power or at maximum 
recommended cruising power.


Paul Lamar                     eng-fars.txt

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org