Bulent Aliev wrote:
There goes my brilliant idea:) My fall-back position is cockpit controlled lip on
the NACA scoop and rotary without a thermostat. On take off the lip will extend
down as a scoop and if the engine starts to cool down, will be retracted to
reduce the opening and the drag. I know someone did it. I believe it was K.
Savier.
Another question: If the NACA scoop is sufficient to cool O-360, do you think
that the same volume of air would cool the rotary?
Bulent
Paul wrote:
Probably not. The rotary burns more fuel for the same power so more
heat is going out the cooling system (and the exhaust for that matter).
Close but no cigar. That assumes of course your cooling system design
is near perfect. Use thin radiators back to back and carefully
designed internal diffusion ducts.
The racers using aircooled engines
for the past ten years have done a lot of developement on cooling drag.
Air cooled engines work on a higher delta T so probably less air
can be used for that reason alone.
I am always amused and amazed
when people bad mouth an aircooled aircraft engine. My ideal
would be an aircooled rotary with an oil cooled rotor and perhaps
water cooled end plates as they are hard to cool with air.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org