Wrathall Mark wrote:
What would be the weight saving of using an Ellison throttle body
instead of EFI, assuming that you could then dispense with the high Px
fuel pump and use a small 5amp hour battery for the redundancy in the
electronic ignition system? This should also negate the need for a
surplus fuel return circuit. I am thinking for a basic VFR RV. (Could
you run two small ignition system batteries in parallel for starting?
VFR avionics have negligible power requirements.)
You got me but not much.
Tracy's ignition system and fuel injection
is a steal. Will work way better than any carb ever made.
Better buy one before Tracy wakes up and raises the price:-)
You will need an electrical system anyway. It is not that much
more weight to put a bigger battery in there. Unless of course
you are going to put a smaller alternator on as well.
The stock Mazda alternator weighs 12 pounds. You might
find one that weighs only five pounds.
Are you building a time to climb racer?
Aerobatics?
If you were to set up a P-51 style duct on an RV-4, how much weight
would you roughly take out of the engine compartment. How many inches
aft would you have to move the wing?
I would not move the wing! That will change the tail volume!
Van would have a **** fit! The airplane might become
un-flyable.
You need to do a complete weight and balance. Water weighs eight
pounds per gallon so don't forget to include that in the weight
of the rad. Keep the big alternator and batteries and move
them up along side the PSRU if necessary. You can always move
the engine forward.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org