Bktrub@aol.com wrote:
Thanks for the diagram, sorry I can't seem to get my design out on the e-mail.
I'll figure it out soon and send it. I'm planning on having a boundary layer
splitter, the inlet should be 2" below the bottom edge of the firewall, the
rad will be mounted on the underside of the main spar, giving a 28" long
inlet duct, shaped somewhat like a trumpet. The Rad will be 25" wide, 9" tall,
and 3-4" thick, depending. Outlet duct will be around 34" long, bell shape in
cross section and incorporating a manual cowl flap. I want to have the whole
works to fit under the existing bottom of the aircraft so as not to breach the
structural integrity of the fuselage.
I'll have to address the oil cooling
with an oil water heat exchanger (probably in the oil pan) with an additional
oil cooler, the location to be determined. I know that this is a fairly thick
radiator, but if it is to be perpendicular to the airflow, and underneath the
aircraft, it cannot be too tall, for ground clearance reasons. I think that
with a good straight in, straight out design, I can get a good pressure
differential, and can adjust the flow in flight with the cowl flap. The
problem would probably be on the ground, so a water mister or fan might be the
solution for taxiing. Any comments, criticisms or ideas are gladly welcome.
I'll be trying to get the diagram aft to you.
IMHO you will pay a drag penalty for this. I would reconsider.
Drag is worth HP cubed.
The only way a P51 style duct makes sense is
if most of it is in the aft fuselage. There you have plenty of
room but you need to be careful to not compromise the structural
integrity of the fuselage.
If an aluminum duct is well designed and securly fastened to
the fuselage with close rivit spacing there will be no problems.
A carbon fiber duct bonded and rivited to the fuselage would
also work. Most of the duct expansion should take place after
the modest size hole in the fuselage lower skin.
If you use the zig-zag-four-thin-radiator scheme you will have
no problems with the elevator push rod. The aerodynamic pressure
drop through those thin one inch cores will be minimal.
See my comments in a previous message for the air outlets.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org