Subject: Warp and IVO props.
From: Paul
Date: 3/17/1999, 10:06 AM
To: zz

tom mayer wrote:

Jeff,

   Several years ago I tried a Warp Drive on an O-320 on my Mustang.  One
blade delaminated severely on the first example they sent.  I tried at least
two other sets of blades.  I got so I could feel what I thought was the
onset of flutter at high rpm at altitudes above 12,000 msl.  I'd go to FT,
which would give 2500 to 2800 rpm, depending on how the blades were set, and
at higher altitudes in a slight dive and sometimes in level flight I could
feel a buzzing, at which point I'd instantly back out on the power and land.
I could not make this happen at altitudes below 10,000. I do not remember
the degree settings I used, but Warp Drive never said anything about
limitations and delamination.   I live in a horrible place to do test
flying, and they were not paying me to risk my neck and airplane, so I did
not do any more than convince myself Warp Drives would not work safely on a
Mustang II at high altitudes.  I have always wondered what was really going
on.  The prop did wonders for take off and climb performance, and was a
little faster than any of several wooden props I had.  You clearly have
great technical expertise, and I wondered if your problems were related to
altitude or just poor design and construction.
   Are your concerns about the Ivo based on the same reasoning, and perhaps
handson experience,  as your objections to the Warp Drive?
   Thanks, Tom Mayer


I suspect the problem is they don't use bi-di in the blades. I think
they are using continuous fiber and consequently the only material
providing shear strength is the epoxy. They are over designed in tension
and under designed in torsion and bending. Sure they are stiff
but that could be the problem and not the answer. 

They need to be wrapped with several layers of carbon 
bi-di atdifferent angles.

If necessary stick it in a lathe and turn down the shank to make room
for the layers of bi-di. Better yet.. machine the hub or machine a new
hub 
for larger diameter shanks.   After that they should be fine. 

If you have one floating around clamp it to the bench and slowly apply 
a torque with lever and weights to the end of the blade. Record the
torque it takes to fail the blade.

Then test it again the same way after the bi-di is applied.

Of course all this is academic for a fast airplane as they have way
too little twist. They should work great on airplanes that take off
at 60 and never go faster than 110 or 120. Check with Don Bates
as he can provide the speed range if any.

Paul Lamar

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org