Jeff Spitzer wrote:
tom mayer wrote:
Jeff,
Several years ago I tried a Warp Drive on an O-320 on my Mustang. One
blade delaminated severely on the first example they sent. I tried at
least
two other sets of blades. I got so I could feel what I thought was the
onset of flutter at high rpm at altitudes above 12,000 msl. I'd go to FT,
which would give 2500 to 2800 rpm, depending on how the blades were set,
and
at higher altitudes in a slight dive and sometimes in level flight I could
feel a buzzing, at which point I'd instantly back out on the power and
land.
I could not make this happen at altitudes below 10,000. I do not remember
the degree settings I used, but Warp Drive never said anything about
limitations and delamination. I live in a horrible place to do test
flying, and they were not paying me to risk my neck and airplane, so I did
not do any more than convince myself Warp Drives would not work safely on a
Mustang II at high altitudes. I have always wondered what was really going
on. The prop did wonders for take off and climb performance, and was a
little faster than any of several wooden props I had. You clearly have
great technical expertise, and I wondered if your problems were related to
altitude or just poor design and construction.
Are your concerns about the Ivo based on the same reasoning, and perhaps
handson experience, as your objections to the Warp Drive?
Thanks, Tom Mayer
We never tested at altitude, only on a test stand. I don't claim to be an
expert on what is wrong with warp drive I just know that I don't like 'em.
My dislike of Ivo comes from what I've seen at Osh and what I've read on
the internet. I have no personal experience with Ivo ownership.
Jeff Spitzer
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org