Lonnie Wood wrote:
----------
Mike Wills wrote:
Lonnie,
How bout some details on that intake manifold? Is that a stock 6 port
lower with all the extra material ground away, or???What about the rest of
the manifold design?
Mike Wills
Mike,
The engine is an '87 13b. You were right about the manifold being stock with
the extra material ground away. I used the lower portion and a few inches of
the mid portion as Tracy Crook did. It differs in that the dynamic chambers
are fibreglass and seperated into an upper and lower chamber and the 3 holes
of the stock
throttle body are maintained. The throttle body was also carved away. The entire
manifold and throttle body weigh about 9 lbs..
The carving on the manifolds was a heck of alot of work. If I had it to do again
I would start from scratch with bent tubes and make a flange to bolt to the block.
This design is still not tested as I have only briefly run the engine with it. All I can
tell you is it didn't blow up and it looks pretty good. Same with the re-drive.
Lonnie
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org