Wrathall Mark wrote:
Thanks Allan for a great run-down on your experience and good advice.
The RV's are fantastic aircraft for those of us who like Metal (and
loath working composites).
Snip
Even in that case it would be best if your engineer
was Dick VanGrunsven.
I think the big problem is that Dick hasn't (yet) built an RxV-7.
Aircraft are always a balance of compromises, and installing a water
cool rotary in the hole designed for an air cooled boxer isn't ideal.
It's a tribute to Dick and to Tracy, Ed, etc that the resulting aircraft
are still so good. If you know Dick personally, remind him that we need
an airframe designed around this powerplant.
Sort of Dave Anders fast back RV-4 with a with a tapered wing. (I know
this is a pain, but only if you have to make each rib former. For a kit
manufacturer who already has the press, once the formers are made, it
should not be a big deal. Simplicity is good, but if you overdo it, you
end up with Volksplanes everywhere.)
Hear hear Mark! Great post!
As far a structural modifications go
you must modify the motor mount to get a rotary in there. The
motor mount is critical. You don't want your engine falling off
if you need to pull out of a dive.
While Dick Van is at he could design in a P51 duct and a laminar
flow wing.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org