Subject: Oil water heat exchangers.
From: Paul
Date: 3/19/1999, 9:59 PM
To: zz

Mike Wills wrote:

At 01:57 PM 3/18/99 -0800, you wrote:
It works like a hand full of soda straws. The air goes through
the straws and the oil finds its way between the straws.
It is pretty easy to make as long as you keep it barrel shaped.

Paul Lamar

Paul,
 Whats your opinion (or anyone elses for that matter) of how this cooler
would work if configured as an oil-to-water cooler rather than oil-to-air?
I have some old surplus intercoolers made in the 50s that I bought as
surplus for $10 each. They are built like this and Ive had some fleeting
thoughts of trying one out as an oil-to-water cooler. Would certainly need
to pressure test them first.

It would probably work.

 If building a water-to-oil cooler do the same rules apply, i.e lots of
surface area(how much?), fins to conduct the heat, etc??  I assume that the
important consideration is still delta T? Any recommended reference
materials on the proper construction of an oil-to-water cooler?

 Most of the oil-to-water coolers Ive seen are considerably smaller than
air-to-oil coolers with comparable cooling specs. Is this because water to
oil has a better heat transfer interface than air-to-oil? Am I the only one
interested in this? It sure would simplify my installation.

Mike Wills

Yes water to oil coolers are more efficient in terms of volume required.

Have you checked the ACRE web site on oil to water coolers built into
the pan? If you do it right start near the bottom and use oversize
and removable water manifolds on each side of the pan you can always 
add more tubes later with the pan removed from the engine.
After it works well you can weld the water manifolds to the pan and
be done with it. Else you can overdo it from the start with 
no penalty as the oil will never get cooler than the water. 

One thing we did not mention, if you you flatten the tubes
over most of their length they will work better. Leave
them round on the ends so they are easy to weld.

Don't forget the water turbulators. 

Tracy Crook has had very good luck with a very rudimentary
oil water heat exchanger in the pan.

Saves the external high pressure oil plumbing.  

Most of the car oil/water hxc's  are too small to do the job.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org