Marvin Kaye wrote:
At 07:10 AM 3/20/99 -0800, you wrote:
Neil A. Kruiswyk wrote:
Marv,
I used 2 Carter (Federal Mogul) fuel pumps normally used with Volvo
500 cui V8 marine engines. They put out 60 to 120 PSI and around 40 Gal/hr.
They're very small, about 7" long and 2" in diameter and are self cooled by
the fuel passing through them. They also have a built in check valve so
plumbing them in parallel is a snap.
Thanks, Neil...
Since you plumb them in parallel can I assume that you have the power to
them setup so you can choose which pump to run? Additionally, what's the
deal on the return line from the fuel rail... is there a restrictor of some
sort in that line to insure that the pressure delivers fuel first to the
injectors before returning excess fuel to the surge tank? Also what did
you do for a fuel pressure gauge?? I've been looking in the ACS catalog
and the only higher fuel pressure gauge I've seen is one by UMA that goes
to 80psi... there was one other that went to 50, but most cap at 30. If
these pumps are capable of delivering 120 it would seem that you'd want to
be able to report max pressure. Any suggestions?
<Marv>
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org