Subject: Fuel pumps for EFI
From: Paul
Date: 3/20/1999, 7:17 PM
To: zz

Neil A. Kruiswyk wrote:

Marv,

    The fuel rail has a pressure regulator at the end of it.  (the blue and
red thing in the picture on the left end of the rail).  Regulated fuel
pressure is an absolute must for the EMU to control the fuel flow through
the injectors.

    The pumps are rated such that the low preasure value is at the max flow
and the high pressure number is absolute max.  I screwed up on the pressures
a bit.  (Too much resin fumes lately)  The pump is good for 80 PSI at 40
gal/hour to a max pressure of 120 (and very little flow).  It's my regulator
that is 60 PSI so the injectors always see exactly 60 psi regardless of duty
cycle and frequancy.  Excess fuel returns to the header tank after going
through the regulator.  A quick rule of thumb..  if max HP is 180 @ .55
lbs/hr/hp = 100 / 7 = 14 gal./hr, so ~2/3 of the fuel going through the rail
is being returned to the header tank.  At these rates you will need at least
3/8" hose back to the header tank (which is what I use).

    And yes.  I have 2 switches for the 2 pumps.  I'm using the EMI engine
monitor which has a couple of AUX inputs.  One of which I made as fuel
pressure with a 0-100 PSI sender.

Neil

Neil-fuel-pump3.jpg
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Neil-fuel-pump3.jpg