Subject: Fuel pumps for EFI
From: Paul
Date: 3/20/1999, 7:37 PM
To: zz

Tracy Crook wrote:

Marvin Kaye wrote:

I'm curious to hear what folks are using or planning on using for fuel
pumps for EFI setups.  What sort of pressures do they need to develop?
Assuming the use of Tracy's controller and stock Mazda injectors, what
pumps would be the best?   We're planning a turbo installation on an '87
TII 4-port, targeting redline at 6300 rpm.  Perhaps the stock injectors
won't be appropriate, any suggestions there as well?  Any info greatly
appreciated.

   <Marv>


I can supply the appropriate EFI pump for use with my controller if you need
them. ($75 each)  They put out up to 105 PSI but of course pressure is
determined by the pressure regulator (Mazda system pressure runs about 36
psi).  I recommend the stock Mazda Turbo injectors.  They flow about 20%
more than the normally aspirated.  If you are just going to normalize or use
very low boost (< or = 5 inches Hg), the normally aspirated injectors will
be fine at 6300 rpm.

Tracy Crook
  rws@altavista.net


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org