Tracy Crook wrote:
Since you plumb them in parallel can I assume that you have the power to
them setup so you can choose which pump to run? Additionally, what's the
deal on the return line from the fuel rail... is there a restrictor of
some
sort in that line to insure that the pressure delivers fuel first to the
injectors before returning excess fuel to the surge tank? Also what did
you do for a fuel pressure gauge?? I've been looking in the ACS catalog
and the only higher fuel pressure gauge I've seen is one by UMA that goes
to 80psi... there was one other that went to 50, but most cap at 30. If
these pumps are capable of delivering 120 it would seem that you'd want
to
be able to report max pressure. Any suggestions?
<Marv>
The return line is from the pressure regulator which should be at the very
end of the last fuel rail. System pressure will run about 36 psi so the 50
psi gauge will work OK. If the pressure goes higher than 40, something is
very wrong. ( unless you are turbocharged, then the pressure will rise
about as much as the boost used.) I use a 100 psi oil pressure gauge
because I had it laying around.
Tracy Crook
rws@altavista.net
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org