Subject: Fuel pumps for EFI
From: Paul
Date: 3/22/1999, 1:57 AM
To: zz

Paul Yaw wrote:


 Marv, and everyone else.

The stock injectors from an '87 flow 550 cc/minute at 43 psi.  At a
specific gravity of .75 (pump gas) that is 217.5 lbs/hr for all four
injectors at 100% duty cycle.  I would suggest not running them past 75%
at peak power.  That puts you at 163 lbs/hr for pump gas, and about 156
lbs/h for 100LL (SG .72)  With a brake specific of .5, that is enough
fuel for about 326 hp.  If you use premium pump gas, you will likely
need to run rich under boost to avoid detonation.  This could easiy put
the BSFC up to .6 or higher.  If you use 100LL you should be able to run
a correct air/fuel ratio (About 13.5:1) because of the increased
detonation resistance.  The Bosch electric pumps are available in two
different sizes.  One is rated at about 300 hp, and the other at about
500.  I would opt for the larger pump.  I don't have the part numbers in
front of me, but I can get them for you.  There is an aftermarket non
adjustable regulator made by Tomco that is set at 52 psi.  This will
increase the flow of the injectors by about 10%

If Tracy's computer does not allow for timing retard under boost I would
suggest running 100LL  If you keep the boost under about 7psi, you can
probably get away without timing retard.  If you use 92 oct. pump gas,
you will have to retard the timing which will increase the already hot
exhaust gas temps, increase the fuel consumption, and reduce power.
Turbos and pump gas will work together, but you are MUCH better off
using a high octane fuel.

I would suggest having the stock injectors cleaned and flow tested by RC
engineering.  Aftermarket replacement injectors are cheap, and NASTY.
You can get them for about $50 as opposed to $250 for the Nippon Denso
pieces, but they are crap.  RC will clean your injectors, measure the
flow rate, and check the spray pattern for about $25 each.

Paul Yaw

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org