Subject: Fuel pumps for EFI
From: Paul
Date: 3/22/1999, 6:34 PM
To: zz

Jeff Spitzer wrote:

Tracy Crook wrote:

The return line is from the pressure regulator which should be at the very
end of the last fuel rail.  System pressure will run about 36 psi so the 50
psi gauge will work OK.  If the pressure goes higher than 40, something is
very wrong.  ( unless you are turbocharged, then the pressure will rise
about as much as the boost used.)  I use a 100 psi oil pressure gauge
because I had it laying around.

This brings up a pet peeve (sp?) of mine.  Most people use guages that are
referenced to atmosphere to measure fuel pressure.  These are called
"guage" pressure as compared to absolute or differential measurements where
a different reference can be used.  At the same time most fuel injection
systems require the fuel pressure regulator to be connected to the intake
manifold so that the fuel pressure will go up and down with manifold
pressure.  So...if you are reading a "guage pressure" sensor on your fuel
pressure then either you convert your MAP to psi and do the math in your
head or you never really know if you've got the right fuel pressure.
Anyone know of a good cheap *differential* pressure sensor to use for fuel
pressure?

Jeff Spitzer


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org