Subject: Oil water heat exchangers.
From: Paul
Date: 3/22/1999, 11:38 AM
To: zz

Mike Wills wrote:

At 08:59 PM 3/19/99 -0800, you wrote:
Have you checked the ACRE web site on oil to water coolers built into
the pan? If you do it right start near the bottom and use oversize
and removable water manifolds on each side of the pan you can always
add more tubes later with the pan removed from the engine.
After it works well you can weld the water manifolds to the pan and
be done with it. Else you can overdo it from the start with
no penalty as the oil will never get cooler than the water.

One thing we did not mention, if you you flatten the tubes
over most of their length they will work better. Leave
them round on the ends so they are easy to weld.
Paul Lamar


Paul,
 Yes, Ive seen it and find it very interesting. Has it been tested by
anyone? If attempting something like this, where do you think the water
should come from, before or after the radiator? Or possibly 2 radiators
plumbed in series with the oil pan cooler between the 2?

That is a good question. My guess is just before the rad
if you do it it in series.

I would not plumb coolers in series. I know it is extra work
to get even  flow in parrallel coolers but you only need do
that once. You will have much better cooling from there on
out. 

Make and use aluminum barrel valves if necessary.
That is a rod with a hole in it placed in tubing welded
into a cross. I'll make a sketch if you are interested.
It will look like the water department shutoff valve in 
your front yard. Once you get it set you can safety wire
it in place. 

Another possibilty is squeeze the hose's with clamps.

Fine tune the cooling system.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org