Marvin Kaye wrote:
At 12:36 PM 3/23/99 -0800, you wrote:
I should let Jeff take over this job :-)
All of that is true but what you really want to know is the difference
in fuel pressure compared to the intake manifold pressure so you know
how much fuel is really being injected as a function of the injector
pulse width.
Jeez, I feel really dense here... if the regulator is already hooked up to
the manifold and is using MAP as its reference point, then is it not true
that fuel pressure will actually vary proportionally to MAP? If this is
the case then the pressure in the system will always be the same relative
to MAP, as that's what the regulator is supposed to do and is the reason
that it's hooked to the manifold in the first place, isn't it? If we gauge
the fuel pressure with the manifold at atmospheric pressure and measure
flow we should then know what the flow rate is for that system. Then, as
the MAP goes up and down, so should the fuel pressure, resulting in the
same flow per time period irrespective of atmospheric pressure, all thanks
to the MAP reference to the regulator. And since the regulator's pressure
is dependent on MAP, then ostensibly the reading we get on the fuel
pressure gauge should actually track the MAP pretty closely so we're
looking at an operating range of what, from 35 to maybe 65psi (if we're
using some boost) assuming that flow rates were calculated with MAP at
atmospheric and we want a MAP-regulated pressure of 50psi.
I guess the thing I don't understand is why do we care? As long as the
fuel pressure gauge tells me that my system has the pressure it was setup
to run at, once I"m flying it's really all I care about. All that other
pressure stuff with the regulator and injector pulse width should have been
handled down on the ground while the engine was being tuned. The pressure
gauge is there only to tell me that my pumps are working as intended... not
to do fuel flow calculations while I'm tooling along at 200mph. Or am I
still missing something here?
<Marv>
You might not care but us electronic nerd types care :-)
Seriously it is one more layer down in the system for
trouble shooting purposes.
I am dealing with that as we speak with my car EFI. Not enough
info. More sensors would narrow down the possible problems.
I know it is running lean. It is telling me it is running lean
but it is not telling me why.
Why Jeff would want it I have no idea.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org