Alan Tolle wrote:
I see another area where I can clear up some confusion.
The comparison between the -4 and the -6 was actually accomplished using my
two very nearly identical aircraft in 1989. Van flew the new RV-6 and I
flew the RV-4 which I had completed back in 1983. Both aircraft were the
first completed by a customer using the production kits furnished by Van's
Aircraft.
The two aircraft were about as identical as you could get them. Absolutely
the same everything, right down to the paint job. I had done some pretty
exhausting flight testing and record keeping on each aircraft individually,
but the 3 mph difference number came from actual side by side flight which
confirmed the data which I had earlier determined on the two aircraft
individually.
It was only some years later that Van finally got his -4 and -6 prototypes
set up with the same engine-prop combination. He repeated the tests and
found the same number, 3 mph.
BTW Van and I did the same side by side comparison between my RV-6 and 6A
again in 1991. The nose gear cost again 3 mph.
A lot of builders thought that the RV-6 would be a slow turkey compared to
the sleek, slender, race plane looking RV-4. But they missed something.
Where are the cheek cowls and the bubble canopy on the RV-6?
I certainly agree that the aircraft of Anders and Saylors are the fast
examples of the two types, though the speeds are not really as fast as the
numbers which are being quoted on these pages. Saylors' clean up is mostly
cooling and airframe drag reduction. In addition to that almost to the
point of fanaticism, Anders flat punishes his engine. He got 145 hours out
of the last one.
All of our talk about cheek cowl drag is just that --- talk. There may be
several ways to actually test the cheek-cowl-produces-drag theory. Lacking
a big wind tunnel, one could build an RV-3 and install the inline LOM four
cylinder engine (air cooled, no cheek cowls, and about 145 hp , I think.)
with a wood propeller and get a lot of good fight test data. Remove the LOM
and install a 150 hp Lycoming (with the cheek cowls,) install the same wood
propeller, and go test some more. Sounds like a lot of work and it might
not prove anything useful.
Hey, if a builder wants to use the factory supplied cowl on the -3 and -4
with a rotary engine conversion, be my guest. I always liked the looks of
the Formula 1 racers. My RV-3 looks like one today with the Lycomiong 180
installed. Alas, it is not as fast as when the rotary was up front.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org