Subject: Taurus radiator construction & weight.
From: Paul
Date: 3/25/1999, 12:55 AM
To: zz

I bought a 1991 3.8 L Taurus rad in the junkyard 
today for $30 because it had a leak in the core 
to header tank joint connection. 
Normally a non-leaking version would cost $100.

That was OK since one should put new aluminum header 
tanks on it anyway. The core alone was 15 by 24 inches and
one inch thick. The tubes ran the long way so the 
Taurus rad is not what you want. 
You want a Honda or Toyoto rad as the tubes
run the short way and they can be cut down to 
a size that will fit in an airplane.

It weighed seven pounds.
That is 0.0194 pounds per cubic inch. Probably typical
for these types of aluminum radiators.

The header tank was easy to get off with a screw
driver by merely prying up the tabs. The gasket was 
age hardened and was made from non-silicone rubber.
That is why it was leaking. Cars are made to
turn to dust on their tenth birthday now-a-days.

A home made silicone rubber gasket should last 
much longer. It looks quite feasible to machine 
new header tanks out of two by two aluminum
bar stock and crimp them back on with silicone 
gaskets. I will do a drawing on this soon.

New header tanks could also probably be welded
on as the end plates look to be about 0.040
to 0.050 thick aluminum. This might be tricky
as the tubes appear to be furnace brazed into
the end plates. I say appear as I am not sure.

They could be merely bonded in with epoxy
from the outside. If that is the case they could 
easily be re-bonded after welding.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

taurad.jpg