Subject: Taurus rad oil water heat exchanger
From: Paul
Date: 3/25/1999, 12:00 PM
To: zz

This is an oil water heat exchanger I found in the 
bottom tank of the Taurus rad.

I don't consider it suitiable for our use because of 
inadequate capacity and the need for high pressure
oil plumbing compared to the water oil heat exchanger
built-into-the-pan scheme.

Never-the-less I found it very interesting because of
its shrewd design. It is made from two very thin 
concentric tubes. System oil heat exchangers are always
a structural problem because of the high oil pressure.
This normally translates into thick material and heavy 
weight unless the device is in the shape of  cylinder
or a sphere. 

This device fits the catagory of the cylinder so it
can be made from .025 thin wall brass tubing.

It only weighs one pound complete with mounting 
nuts washers and gaskets and I am sure Ford went with
it because of the low cost rather than the light weight.

The OD is 1.75 inch and the ID of the inner tube is 
aproximately 1.50 inch. The cool water circulates
on both the inside and the outsides of the two
brass tubes.

BTW this points up another subtle advantage of
the oil pan oil/water heat exchanger. There is no.. 
none.. nata.. high pressure oil plumbing or
parts of any kind.
 

Paul Lamar          tauhexc.jpg
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

tauhexc.jpg