Anderson Ed wrote:
Jim,
I think you did an excellent job in containing your bird's weight. I
think I got a little carried away with redundancy and "over
engineering", some less than optimum design decisions and putting a full
IFR panel (just in case) was probably unnecessary as I do not intend
finding myself in IMC. In any case, if I can get another 15-20 hp out of
this 13B which most appear to think is doable, then my 130 lbs extra
won't be as noticable.
Based on your prop and rpm I would say you are getting about what I am
in HP. I estimate based on my performance compared to an RV-6A at the
same loaded weight to have a 150-155 HP engine. I get a slightly
greater rate of climb but slightly less top speed. My prop is a
Performance 68x72, so a little less pitch would give a little better
climb and a little less cruise than your 68x72. I believe you
indicated your top speed was around 185 MPH and mine to date is 183 MPH
TAS based on GPS calibrated airspeed. A redo of the intake manifold is
high on my list of things to accomplish. But, not having much luck
finding prebent alum tubing of the size recommended by Paul Yaw, so may
just go with thin wall stainless or mild steel.
Any word from Chris on the cause of your "Drone".
Ed Anderson
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org