Subject: The oil thing again.
From: Paul
Date: 3/26/1999, 8:39 AM
To: zz

Wrathall Mark wrote:

Snip

At 500 degrees it does indeed come apart. It leaves
a nasty gummy residue.  Open all the windows
in your kitchen and get rid of the wife for a
few days and try it :-) Mobil 1 breaks down into two
components. A low viscosity component and a black higher
viscosity component. Two cycle and turbine oil beats both of these
by a bunch.

Is this all there is to the story? How do these oils break down under
heat combined with pressure and fuel dilution?


I have no idea Mark. Paul Yaw likes to mix them with gasoline
and burn them. He confirms two cycle oil as being the best.
We are looking for a tip seal oil to primarily cool the
tip seal which can run to 500 F under full power conditions.
No way is this test to be construed as a valid system oil 
test. 

With two cycle oil cooling and lubing the tip seals
a Mazda rotary ought to last almost forever considering how
bad regular motor oil is at 500 degree breakdown.

 
Snip
 BTW the Mazda silicone oil control o ring has been soaking at
least a week in turbine oil with no problems so far.

 In the airlines we sometimes have problems with certain turbine
oils coking in certain engines. Turbine oil will not normally come in
contact with combustion. The heat they absorb is mostly from the seal
pressurization air (Normally compressor discharge air) and via
conduction through the spools and disks. The seals in the gas path are
not lubricated, rather labyrinth type.

Maybe I should burn a little turbine oil and see what
happens.

Paul
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org