Paul Yaw wrote:
Everybody,
The combustion process is separated from the oil in the same way that it
is in a piston engine. With seals! (OK, they call them rings.) They do
not seal perfectly, but they do seem to have less blow by than a piston
engine, but as the side seals, oil seals, and side housings wear, the
leakage increases. This is especially true if your engine has been
rebuilt by a hack who did not resurface the side housings, and replace
the side and oil seals. Mazda's spec for side seal to corner seal
clearance for a "rebuild" is no greater than .007" Jeez, you could
drive a truck through there! A new engine from the factory is
clearanced at about .002" Most "rebuilds" do not include new side seals
which is absolutely ridiculous. In addition to the big gaping hole
between the side and corner seal, used side seals are rarely flat. They
normally show more wear in the area that passes the intake ports. This
is especially true with six port engines. A cheap rebuild (non surfaced
side housings, used side seals, and sometimes used oil control rings.)
is easy to spot. Just smell the oil! In most cases thay are so bad
that the oil reeks of gasoline after just a few hundred miles. Mazda
competition used to offer a stiffer outer oil control seal spring. They
are now standard issue for the twin turbo RX-7. If you do your own
rebuild, use 93+ springs. That goes for the corner seal springs as
well.
Oh hell, while I am on my soap box, I might as well keep going. Use the
93+ rear oil pressure regulator, and groove the water jackets in the
rotor housings as per the instructions in the Racing Beat catalog. If
you don't have their catalog GET IT before you rebuild your engine.
When clearancing your seals, screw the Mazda "rebuild" specs. Build it
to NEW engine specs. It doesn't cost much more to do it right. And
PLEASE have your side hosings resurfaced. Racing Beat and Mazdatrix
both have lapping machines. A brand new (flat) oil control ring will
not seal worth a damn when mated to a non flat side housing. This goes
for the rest of the seals as well.
I just meant to comment on the blow by issue...I guess I got a bit
carried away!
Paul Yaw
Great advice Paul. Thanks for sharing that. I like that kind
of pratical information born of experience.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org