Anderson Ed wrote:
Paul,
My understanding is that NPG is not what you want for the rotary. While
the greater Delta T of NPG does enhance heat transfer between the
coolant and the air, the lower specific heat for NPG means that less
heat energy is carried per unit volume of the liquid. This would seem
to imply that you either need to increase the flow rate or else you will
not be transferring heat from the block to the radiator as fast as you
would with say H20 (higher specific heat). For a race engine retaining
heat in the block giving greater thermal efficiency and more speed/miles
per gallon makes sense as the reciprocating engines are somewhat less
adversly affected by higher oil/coolant/block temps. However, given the
sensitivity of the rotary to heat, it would appear that the best coolant
for maximum heat transfer from block to radiator would be water. If
memory serves me correctly, the EGW has a specific heat of approx 0.5
which when mixed 50/50 with water (for anti freez/corrosion protection)
gives a mixed Specific heat of around 0.75. I noticed about a 5-8F
difference (higher) in coolant temp when I used the 50/50 water/coolant
mix over just using water.
So, given the senstivity of the rotary to elevated block temps, it just
does not appear that NPG is the way to go. Did I miss something or is
my understanding flawed.
Ed Anderson
Good info Ed.
I think we all now agree on this. Chuck was a holdout for awhile :-)
Paul
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org