Stephen Opgenorth wrote:
Neat history of the Turbo compound development. The question is can it
practically be applied to a homebuilt, rotary powered or otherwise? I've
heard from a couple of old guys that flew them, that the R-3350TC was a
mechanics and flight engineers nightmare to keep running. And, that if it
hadn't been for the fact that the great BSFC made longer range flights with
higher payloads possible, the airlines couldn't have justified the cost to
keep them running. The joke was "why did they put four engines on it?
because a _normal_ approach uses three!"
In order to be a viable thing for a single engine homebuilt any power
recovery system would have to be "fail safe". If the system fails at any
point, the engine MUST keep working at least long enough to make a safe
landing. One approach would be to keep the power recovery separate from the
main power plant. A system something like the attached sketch, extending
from the side of the cowl (one on each side, i.e. one for each rotor) might
work. It would look something like a Cri Cri with two tightly faired
little pods sticking out but with the main prop in usual place. Just paint
the plane green and call it "Le Grasshopper" ;-)
It would give you completely redundant induction systems (you'd need to have
EFI) and, properly designed, you could get some intercooling if you put
cooling ribs on the induction manifold and perhaps a fairing around it. The
longer exhaust run to the turbo should also help keep the TIT down a bit.
I don't know with what sort of efficiency this system would turn waste
energy into usable thrust, or if you could build it small enough, light
enough and low drag enough to end up with a net gain to give you more mpg.
Any engineer types out there with the urge to do an analysis? Well that's
my wacky idea for the night :-)
..Stephen..
We discussed all that about six months ago. Turns out the small props
are not very efficient. One off the shelf turbine gear box is all you
need.
One of the reasons the R-3350 TC was failure prone was because if you
lost
a peice of the exhaust valve it would take out the turbine on its way
out as well. The rotary of course has no poppet valves to break up.
Besides... that was with 1950's turbine material. It should now be no
less reliable than a turbofan engine.
You could always free wheel the turbine if it failed. You would only
lose about 20% of your peak power.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org