Subject: Exhaust systems/ peripheral ports
From: Paul
Date: 5/1/1999, 10:55 PM
To: zz

Paul Yaw wrote:

Paul wrote:

Mike Wills wrote:

 Ive been looking at the tuned and un-tuned mufflers depicted on Paul's
ACRE website. Any comments regarding how these would perform on a 13B
configured about like Tracy's (yeah I realize Tracy is using a muffler that
is essentially Paul's untuned version). What Im wondering is how they
compare power wise to each other and then to a conventional header? And
then throw Ed Anderson's design in too, with totally independant pipes how
would it stack up against the others?

 From what I understand the greatest gains to be made in a normally
aspirated rotary is in the exhaust tuning. So what do you experts say?

 Still waiting to hear comments regarding peripheral porting in the 4500 -
6500 rpm band, and suitability of off the shelf (i.e. Racing Beat)
peripheral port housings in this rpm range.

Mike Wills

A "race" peripheral port will probably make peak torque above 7000 rpm.
If I had to build one for this application, my starting point would be.
IO = no earlier than 80 BTDC, IC = 50 to 60 ABDC  I would probably use turbo
rotor housings with stock port timing. EO = 73 BBDC EC = 48 ATDC  I would
probably have an inlet pipe diameter of 1.5"  That is where I would
start, but keep in mind that this is just an educated guess.  Some days
I guess pretty well, and other days I think I am in the wrong business.

Good luck

PY

What guess on intake pipe length Paul Y?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org