Subject: Sprag clutches in PSRUs
From: Paul
Date: 5/1/1999, 8:00 AM
To: zz

Charles P. Kuss wrote:


Rotor heads,

 I have helped troubleshoot a hammering noise on a friend's Subaru
Kitfox utilizing the NSI PSRU. One of the factors causing early failure
of the sprag clutch is the light weight of the composite prop combined
with a low idle speed. The lack of forward inertia due to the light prop
weight, causes the prop to unload at low speeds. When this happens, the
prop freewheels in it's normal direction of rotation. It is actually
rotating faster than the engine/psru is driving it. This is how the
sprag clutch isolates the torsional mode.

 The problem is that shortly (less than one second) after, the prop
decelerates. This causes a collision as the sprag clutch must stop the
prop from decellerating below the speed at which the engine/psru are
attempting to drive it. This happens with considerable rapidity; which
is
heard as a sort of "jackhammering" sound, coming from the front of the
PSRU (where the sprag clutch is located). This constant
engaging/dis-engaging of the rollers of the sprag clutch are the cause
of it's premature demise.

 The owner of this Kitfox had been advised to set his idle rpm to
800-1,200. This speed was insufficient to insure that the prop would not
unload. Raising the engine idle speed to 1,500 rpm was the quick & dirty
solution to prevent this from happening. Of course, this does nothing
good for fuel burn.
 The use of a heavier prop would allow a lower engine idle speed.
Conversely, it would place more strain on the PSRU and it's sprag clutch
at higher power outputs. Anyone interested in this subject should read
the article at the URL below.

http://www.prime-mover.org/Engines/Torsional/contact1/contact1.html


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org