Subject: Aircraft engine set up for the rotary.
From: Paul
Date: 5/3/1999, 8:09 PM
To: zz

Jeff Spitzer wrote:

At 12:54 PM 5/3/99 -0700, you wrote:

Here are the engineering specs on silicon nitride seal material.
Note the half density. The 3 mm silicon nitride seal is lighter
than the 2 mm cast iron.

I thought were comparing apples to apples here.  If you throw ceramics into
the mix (at what cost?) then that really muddies the waters.  I forgot the
stock seals were cast iron.  Aren't some people running 3mm ferrous apex
seals?

Jeff Spitzer

The Ianette ceramic seals are about $200 each unless you get St. Gobain
or Kyocera to make them for you.

http://www.kyocera.com/kicc/diesel.html

I am not sure about the 3 mm iron. I forgot what year Mazda switched
over.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org