Subject: Aircraft engine set up for the rotary.
From: Paul
Date: 5/3/1999, 9:09 PM
To: zz

Paul Yaw wrote:

Paul wrote:

Jeff Spitzer wrote:

At 12:54 PM 5/3/99 -0700, you wrote:

Here are the engineering specs on silicon nitride seal material.
Note the half density. The 3 mm silicon nitride seal is lighter
than the 2 mm cast iron.

I thought were comparing apples to apples here.  If you throw ceramics into
the mix (at what cost?) then that really muddies the waters.  I forgot the
stock seals were cast iron.  Aren't some people running 3mm ferrous apex
seals?

Jeff Spitzer

The Ianette ceramic seals are about $200 each unless you get St. Gobain
or Kyocera to make them for you.

http://www.kyocera.com/kicc/diesel.html

I am not sure about the 3 mm iron. I forgot what year Mazda switched
over.

They switched in '86  The 2mm. seals are three piece and have two
springs.  One full length, and one short one that fits inside of the
long one.  It looks like it would distribute the spring force more
evenly.  Is there any chance that the 3mm. seal would handle heat loads
better?

PY

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org