Subject: Decision, Decision! Nitriding side housings.
From: Paul
Date: 5/3/1999, 6:03 AM
To: zz

Anderson Ed wrote:

Pebvjs@aol.com wrote:

Ed,

Check places that regrind racing and high performance crankshafts on getting
the side housings re-nitrided. The process as I recall involves putting the
part in an oven filled with the appropriate gas (boron nitride or some such)
and heating to get the hardening. Sometimes the cranks would warp from the
high temp. used and would have to be straightened after the process.
Also, from previous discussions on this forum should you not be looking for 4
port side housings if you have to change yours? Does anyone know if all
engines after 1988 are 6 port?

Ed sadler           pebvjs@aol.com

 > Hi Ed,
  The 89-92 FCS3 GTX Turbo II blocks are all four ports but there are
six ports normally aspired blocks for those years as well.  I intend to
use an 89-92 Turbo II block with higher compression (9.7 CR) normally
aspired rotors from the same years.  Begining to think that the brand
new 1988 turbo II block from the marine source may be the simpler
answer, the only problem is that it has the low 8.4 compression ratio
turbo rotors and runs normally aspired.  Having redone housing nitrated
begins to sound more involved that I wanted to get in this project{:>}

Ed Anderson


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org