Jeff Spitzer wrote:
Todd Carrico wrote:
Ed,
At Superior, one of the reasons we went with through hardened barrels was
because Nitrided barrels are more suceptable to corrosion. Nitriding can
get pretty High Rc ratings (low case depth though), and through hardeneing
gave us the hardness that we needed. Also, Nitriding is a process that can
be done after lapping, I think. I have never priced it, but it may cheaper
to have them lapped and nitrided. Cheaper than $3k I would imagine.
tc
I wouldn't re-nitride end housings unless you are sure all previous layer
has been removed. In general not a good idea. I further would not consider
nitride after lapping. Even though in theory there is negligible
dimensional change, in reality the purpose of *lapping* is to remove
"negligible" dimensional defects.
Jeff Spitzer
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org