Subject: Exhaust systems/ peripheral ports
From: Paul
Date: 5/3/1999, 12:26 PM
To: zz

Mike Wills wrote:

At 10:55 PM 5/1/99 -0700, you wrote:
Paul Yaw wrote:
A "race" peripheral port will probably make peak torque above 7000 rpm.
If I had to build one for this application, my starting point would be.
IO = no earlier than 80 BTDC, IC = 50 to 60 ABDC  I would probably use
turbo
rotor housings with stock port timing. EO = 73 BBDC EC = 48 ATDC  I would
probably have an inlet pipe diameter of 1.5"  That is where I would
start, but keep in mind that this is just an educated guess.  Some days
I guess pretty well, and other days I think I am in the wrong business.

Good luck

PY


Thanks Paul,
 So the next question is how do these port timing numbers and port size
compare to the out-of-the-box peripheral port rotor housings from RB? I
suppose the ports could be sleeved and then bored to vary the timing somewhat?
 Even if the peripheral port engine made no more power than a side port
engine I think it would be advantageous due to the simplicity and light
weight of the 2 runner manifold.

Mike Wills

Here is a scale drawing of the Lemans engine. If you print this
and measure the rotor tip from apex to apex you can scale the
port timing and port sizes directly from this drawing.

lemaneng.jpg

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

lemaneng.jpg