Subject: Exhaust systems/ peripheral ports]
From: Paul
Date: 5/4/1999, 8:13 AM
To: zz

The subject of periperal port timing recently came up.

You can scale the drawing of the Mazda Lemans engine 
(lemaneng.jpg) that I recently uploaded or go on the
chart attached below (pptime.jpg) from Mazda SAE paper 841017.
This paper has a lot of tuning information on intake and exhaust 
pipe lengths and port timings.

Scaling, if done carefully will be
more than adequate. Just print it as large as you can.

The intake port timing is not that criticle.
Notice from the chart below at 5000 RPM there is no difference
for a wide range of peripheral port closings.

The peripheral port location and opening is mainly
determined by a tension bolt in the housing. The port will
only fit in one place more or less.

Mazda spent millions developing the Lemans engine. You are not going to
do any better than they did so you might as well just copy them exactly.

Mazda tested the heck out of these things for years. Winning Lemans
with a fuel quantity restriction was no easy task.

I suggest you get a copy of SAE paper 920309 on the Leman engine as
well.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

pptime.jpg