Subject: Exhaust systems/ peripheral ports
From: Paul
Date: 5/4/1999, 9:55 AM
To: zz

Paul wrote:
I will anticipate your next question.
"What about low speed torque with peripheral
ports?" My answer is: it is just not needed with a prop
load.

Assuming that prop load HP is proportional to
RPM cubed you can plug the actual Lemans engine HP
as a function of RPM into this prop load chart and see 
if there is any excess HP avaialble at lower RPM's
to accelerate the prop RPM's. I think there will be.

I suspect the static thrust might be slightly
lower with a peripheral port engine but it
should build up much faster as the airplane
starts moving.

I added half the Lemans peripheral port HP data
to the lower chart to see just how much excess HP
was available at the lower RPM levels.
This is with a fixed pitch prop set for
6250 RPM max. My guess on this pitch was slightly
off for the Lemans engine porting. With
this engine, more pitch could be tolerated.
A variable pitch prop of course would give much 
much better low speed aircraft accelleration.

As you can see low RPM torque (or HP) has little to do 
with it.

Engine    Prop Load      HP available
RPM       HP Required    from 2 rotor PP

 1000       1
 1250       2
 1500       3
 1750       5
 2000       7
 2250      10
 2500      14
 2750      19
 3000      24
 3250      31
 3500      39
 3750      47
 4000      58             117
 4250      69  
 4500      82             140 
 4750      96
 5000     113             160 
 5250     130
 5500     150             180  
 5750     171
 6000     194             241 
 6250     220  
 6500     247             274 
 6750     277
 7000     309

 
Paul Lamar


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org