Subject: Removing the oil injection pump.
From: Paul
Date: 5/4/1999, 11:32 PM
To: zz

Lonnie Wood wrote:

----------
Brian D. Cain wrote:

What kind of two cycle oil are we talking about here and in what ratios?
I'd like to get my hands on a brand-name and go spend some of this money
burning a hole in my wallet.

B


One once per gallon.

Almost any kind works fine.
Forget the oil injection pump and disconnect it.
Your engine will like you much much better.

Sounds good but I have a question. Should the pump be
simply disconnected or can it be removed and a block off
plate made without taking the engine apart to take out the
drive shaft? I remember reading about somebody that had
fluctuating oil pressure because this drive shaft was not
removed. Can this happen?

Lonnie

I don't think disconnecting it works. It gets it oil supply
through its mounting base. It looks like you would have to 
machine a rather thick block off plate to allow the shaft
to protrude out of the front cover about 3/8 of an inch.
Maybe not.

Of course you could take off the front cover and remove the 
shaft altogether. There appears to be a roll pin you must
remove to get the shaft out. 

In Tracy's  "Aviator's Guide To Aircraft Conversions"
the bible of aircraft conversion he talks about 
this procedure. There is also an oil passage that 
needs to be blocked.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org