Ken Powell wrote:
Paul,
I would like to share some info about 2-stroke oils with everyone.
This is a pragmatic observation based on 20 years of racing motorcyles
and 5 years of working as a motorcyle mechanic (BTW, I was working in
a Suzuki shop in 1975 when the RE5 was introduced. What a beautiful
motor!) I am not a petroleum engineer (I'm a programmer) so you can
take this with a grain of salt. First of all, note that 2-stroke oils
are formulated based on the anticipated operating temperature. I
would like to break this into 2 groups; water cooled and air cooled
engines:
1. Water cooled engines can use a TCW-III approved oil successfully.
These oils are widely available from Mercury Marine, OMC and yes, even
Walmart. I believe that all of the outboard oils sold by the outboard
companies are petroleum based and these are much cheaper than synthetic
oils.
2. Air cooled engines run considerably hotter at the upper end of
their operating range and have a big problem with carbon in the ring
lands. Pistons which utilize a dykes ring seem to suffer from this
more that other designs. Penzoil makes a petroleum based oil for air
cooled 2-strokes that is very popular with snowmobiles and Rotax
2-stroke airplane engines. However, I rode Maico motorcles for about
10 years and they used a Mahl piston with a dykes ring. Ring
sticking was a constant problem. I tried many different oils and
what worked for me was an oil called Golden Spectro - the dykes ring
did not sieze due to carbon build up. Conclusions:
1. I would use Golden Spectro or Penzoil for air cooled engines on
a 2-stroke powered airplane. Golden Spectro mixes at a 40:1 ratio
in a motorcycle.
2. I will use a TCW-III oil in a rotary powered airplane. I think
that the oil cooled rotor's temperature will stay within the operating
temp range of these oils. At this time I have no preference for a
particular brand. Note that a petroleum oil will leave a protective
film to prevent rust while the synthetics generally run so clean that
no film is left to prevent rust. While is is true for a recipricating
engine, I'm not sure if this is applicable to a rotary.
3. I believe the synthetic oils are far superior to petroleum based
oils, but I think this is overkill for our application. However, you
could probably mix a synthetic much leaner if carrying the oil was a
problem due to limited space or payload (or CG).
Ken Powell
The apex seal runs about 500 degrees F at full power.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org