Subject: Marine use of rotary engines.
From: Paul
Date: 5/6/1999, 7:43 AM
To: zz


Hello Paul:

I've also heard about using two stroke oil mixed in the fuel. I haven't tried
it, but it makes a lot of sense. Two stroke oils are specifically designed to
go through the combustion cycle, while four stroke oils are not. It's just
too bad two stroke oils aren't suitable for the engine bearings, one could
run the whole engine on the stuff.
I'd recommend 100:1 ratio for a naturally aspirated engine, not run above
6000 rpm. For higher speeds, I'd add more oil. For turbo or supercharged use,
I'd go all the way to 50:1, and it would probably smoke a little.

Ceramic seals -- I have experience in heavy duty applications, both Mazda and
large experimental rotaries (650 hp per rotor running on diesel fuel. The
rotors each weighed 120 lbs -- if you interested, I'll tell you more another
time). The ceramic seals will last for 4 to ten times the life of metallic
seals, and can operate under much higher pressures. They are very expensive
because they must be manufactured FLAWLESSLY. Any small (microscopic) defect
near the surface can cause the seal to break. For most uses, the apex seals
are not the life-limiting part in the engine. In marine applications, it is
more likely that after many seasons of use something in the cooling system
will fail and the operator will let the engine overheat badly, or the boat
will sink, or some other catastrophe will happen. It's unusual for boats to
get more than 100 hrs per year in recreational use. I have no ceramic seal
experience in racing.

We have one commercial customer with 950 hours on his engines, no problems.
He carries people and equipment to remote logging camps in British Columbia,
Canada, and hauls logs, Christmas trees, and other forestry products. He has
a 36 foot welded aluminum jet boat, triple engine, hauls five tons at 30
knots running 5000 rpm continuous for five hours at a stretch. He has really
proven the durability of these engines. If you'd like, I can mail or fax you
a testimonial letter he wrote for us. I'd have to guess the engines are good
for 2500 to 5000 hours on average, more with careful use and maintenance.

These are Mazda based engines.
Please do not re-publish this anywhere. It was sent to me as private
email. I would not like to see it all over the internet.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org