<Mucho snip>
2. I will use a TCW-III oil in a rotary powered airplane. I think
that the oil cooled rotor's temperature will stay within the operating
temp range of these oils. At this time I have no preference for a
particular brand. Note that a petroleum oil will leave a protective
film to prevent rust while the synthetics generally run so clean that
no film is left to prevent rust. While is is true for a recipricating
engine, I'm not sure if this is applicable to a rotary.
Ken Powell
<Mucho snip>
Wow, that's weird. I just burned some of that TODAY to see what would
happen. First, I could not get it to burn. I just dumped some on a
piece of aluminum and hit it with a torch. It didn't thin much from the
heat, and it finally gummed up a bit and turned brown. So I heated it
some more and guess what...The brown gum dissapeared. I mean it just
plain went away, and I was left with a clean piece of aluminum. I am
not kidding! Try it yourself. I guess that it didn't burn because the
aluminum was pulling so much heat out of it. Jim Mederer brought up a
good point about burning these oils to see how much crud they leave
behind. He was interested in what kind of crud was left behind, not how
much. His contention was that a lot of slippery goo was better than a
little bit of abrasive ash. Why didn't I think of that? My buddy Pat
who was a wholesaler in the motorcycle business for years says that just
about everyone across the country carries it.
Paul Yaw
One of Marvel Mystery oil's claims is that when it burns, it leaves a
lubricating residue. Says so on the outside of the can. If it is in black
(er red) and white, it must be true <grin>
Todd Carrico
In our test of Marvel Mystery Oil (one hour at 500 degrees F) it
came out on the bottom of the list. I think even Tracy has given
up on it :-)
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org