Brian D. Cain wrote:
That was the first idea I had about it but I haven't looked inside the
back of a front cover in quite some time so I couldn't visualize it.
Also there's the issue of keeping that (x):1 ratio constant and RPM
variable.
I really, really like the idea of doing away with the heavy-weight oil
injection. I'm starting to wonder if it does more harm than good.
B
The neat thing about the fuel mix is the oil injested
along with the fuel is proportional to power.
The galleries I mentioned are visable from the front
of the engine. At least on the old one-distributor
front cover I have. One runs horzontally across the
cover just below the eccentric shaft and the other
runs upwards and outwards at about a 30 degree angle
off the verticle looking from the front of the engine
at the right side of the front cover. They both are plugged on
their ends. Either plugged end could be used to feed
the 2 cycle oil in.
Here is a picture from my favorite Mazda rotary engine
overhaul manual. Glen's Tune Up and Repair Guide.
Covers R-100, RX-2, RX-3, RX-4, 12A and 13B engines.
A real collectors item. 100's of pictures.
frtcover.jpg
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org