Turrbie@aol.com wrote:
In a message dated 5/7/99 5:55:40 PM Eastern Daylight Time,
rotaryeng@earthlink.net writes:
Russell Kent
>
That is a very good point Russell. Mazda got carried away by the smog
rules and cut way back on the amount of oil injected in the late
engines. Probably too much IMHO. That is why Mazda needs special
oil and a separate supply.
The early pumps had a mechanical connection to the throttle so it
is probably easy to increase the supply. This I think was used
through 1991. It is called the "metering pump connecting rod".
Some models had the electronically controlled pump. This has
a stepping motor which takes the place of the throttle linkage.
If you can figure a way to lock this in "high" you are home
free. Now you have excess oil at light load with oil amount
proportional only to RPM. All second gen RX7's probably had
the stepping motor metering pump.
I would forget it and mix the oil with the gas :-)
One less thing to fail.
Paul Lamar
I looked at using the stock pump as well, but the same oil used to feed the
pump is also used to lube the metering pump drive shaft. I interpreted the
design to feed a supply of oil to the metering pump but not under pressure.
Hence, the jet machined into the front housing and the open drain area around
the metering pump shaft are to bleed off any excess oil or pressure. If you
tried to block off the oil supply before the shaft, then of course, the shaft
will go south. Since the metering pump has no shaft seals, there is also the
probability that even if you connect your 2 cycle supply directly to the
pump, you will have leakage and 2 cycle oil mixing with the engine oil.
As Paul said, Give up and premix.
Bruce Turrentine
Good points Bruce.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org