Subject: External pump for 2-stroke oil
From: Paul
Date: 5/7/1999, 8:11 PM
To: zz

JMLBlues@aol.com wrote:

The Mazda oil metering pump, I believe, is NOT pressure fed. If my memory
serves correctly, the pump receives its oil after the metering pump drive
shaft bearing. It is essentially an atmospheric feed. I believe (again, not
sure) that if you feed that little mikuni with 50 psi oil you'll just blow
right by its metering elements.

There were two mechanical metering pumps available on 13B engines. The NA
engine had a pump with the number 246 on the lever. The Turbo engines had
number 318 on the lever. The 318 delivers considerably more oil. Also, note
that it is important to maintain Mazda's air bleed nozzle contraptions if the
metering pump is feeding anyplace that sees vacuum -- the rotor housing or
the intake manifold. The function of the air bleeds is to "break" the suction
on the metering pump. If the metering pump sees vacuum, oil in the lines and
in the pump will be sucked out. The overall oil delivery will be disrupted.

Regarding two stroke oils -- While the cook test is a nice coarse measure of
deposit forming tendencies, there is A LOT more to oil than that. First of
all, the following factors are known to influence the deposits formed in
bench test such as has been described -- the material the oil is being
"cooked" on will have a catalytic effect on deposit formation, the
time-temperature history (how fast its ramped up, how long it stays at any
given temperature), the atmosphere, the amount of oil in the puddle... There
is actually an ASTM test called the "Panel Coker Test" which establishes the
proper methodolgy for doing this type of thing.

I used short cat food "tin" cans :-) Pre-heated the oven to 500 degrees,
opened the door and stuck the can in for an hour. One teaspoon of
oil.

Oils contain other additives
which may or may not be important in rotary engines. One type of additive is
called "anti wear" which creates microscopic chemical films on metallic
surfaces. These films protect the microscopic high spots ("asperities") from
welding together ("adhesive wear" or "scuffing") when the so-called
thick-film lubrication regime breaks down. The type of anti wear additives
are different in two stroke oils. The viscosity characteristics are also
important. Not just the "SAE" rating, which is only a measure of how fast an
oil will flow through an orifice at a particular temperature, but also
something called the "pressure-viscosity" coefficient. This is a measure of
the viscosity of the oil when it is trapped between two surfaces under high
loads -- exactly the situation where the apex seal meets the trochoid. Two
stroke oils are very specialized products, as are the conventional "motor
oils" which are commonly used in piston and rotary engines. Unfortunately,
none of these highly engineered products was produced with the special
requirements of the rotary in mind. Two stroke oils have some promising
characteristics, but I'd want to see A LOT of testing before I was sure it
was the right thing to do.

Great info Jon thanks.

So far we have had excellent results with two cycle oil mixed
with the gas as have a myriad of car racers. Tracy Crook has 
about 600 hours in an aircraft using Marvel Mystery Oil mixed 
with the gas. Two cycle oil has got to be an improvement on that :-)

The engine still looks clean after 820 hours looking through
the exhaust ports. More than you can say for most car engines.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org