Paul Yaw wrote:
Paul wrote:
I am rather surprised it is going into a 3500 pound gross, 45 foot
wing span airplane with a 2.17:1 PSRU. I would let it rev more
and use something around a 3:1 PSRU. I would also definetly
try to get an electric variable pitch prop to work.
If the rotary survives in this application it will survive in
anything. This is severe duty indeed.
Not knowing what kind of resonances might be involved with a prop and
PSRU hanging off the engine, I decided to run the engine in the same rpm
range as previously successful AC rotaries. I am a coward. My thought
was that if there was a failure brought about by boosting (detonation)
the engine would still run, but at less power. If the reduction unit or
eccentric shaft broke it would be ugly. The main difference between
this and the other airborne engines is the turbo. The effect of the
turbo could be tested on the dyno, but the effect of high rpm operation
on the drive and everything else could not, unless I adapted the water
brake to the PSRU. That would have been a huge amount of work. If I end
up building many more AC engines I will reconfigure the dyno. In that
case I will not have to worry about the effects of frictional loss, and
the PSRU will be tested before flight. I think that this would be the
best approach. It does have an elctric variable pitch prop made by
Ivo. Sven was not too happy with the construction quality of this piece
so it may be changed at some point. I can't wait 'till this thing
flies!
I dropped off the film today so I should have pictures of this cute
little engine by Monday. As for the runs comparing the SDS igniton to
the MSD, I still have not remembered to take a floppy when I leave in
the morning. I think I am getting a young mans version of Alzheimers
Disease.
In response to a previously unrelated post, to convert from the new SAE
correction factor to the old one divide by .9615. I use the old one
which is commonly referred to as STP
PY
We have some people running a 3:1 Ross C6 planetary PSRU in gyro's.
Another 1000 or so RPM does not seem to hurt. Don't worry Paul.
BTW What kind of PSRU is Sven planning on using?
He should dump that IVO prop and call these people.
It is well made and there is a world of difference.
I had a good look at Sun N Fun.
He is going to need a good prop with that airplane.
They will have a booth at Oshkosh 1999
July 23rd - August 3rd
South Aviation Exhibit Hangar "D"
Aisle D, Booth #4071
ADDITIONAL INFORMATION AVAILABLE:
AERO TRADING LIMITED
160 Rockfield Road
Penrose, Auckland, New Zealand
PHONE: 64-9-579-1221
FAX: 64-9-579-1403
SALES EMAIL: Sales@Propellor.com
ALTERNATE EMAIL: Aerotrad@ihug.co.nz
http://www.propellor.com
I have no interest in this company of any kind in case some newbies
are wondering. I just know how hard it is to design and build
a good three blade variable pitch prop.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org