Subject: Affect of loss of lubrication and cooling on the apex seals.
From: Paul
Date: 5/9/1999, 12:18 PM
To: zz

This is from SAE paper 860560 Material Technology Development
Applied to Rotary Engine at Mazda.

Mazda has done some excellent work. We are so lucky
to have access to these engines at such low cost.

As you can see the temperature difference between the bottom
of the seal and the top of the seal increases at high HP probably
causing the seal to bow and lose pressure.

Again Si3N4 ceramic seals should reduce this effect.

This may be one of the reasons Mazda decided to go with the 
three peice  hardened cast iron seal.

The bottom line is make sure that seal is getting plenty of oil 
to first cool it and then lube it.

As far as the lube goes it is important to find a lubrication
that will stand up to high temperature, as the rotor housing 
surface, as I have shown runs very hot, at 170 degrees C or so. 
Two cycle or turbine oil according to my 500 degree F oven bake 
tests seems to fit those needs.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

apextemp.jpg