Subject: Affect of loss of lubrication and cooling on the apex
From: Paul
Date: 5/9/1999, 9:09 PM
To: zz

Turrbie@aol.com wrote:

In a message dated 5/9/99 2:46:51 PM Eastern Daylight Time,
rotaryeng@earthlink.net writes:


 This is the temp distribution in the rotor housing.
 Here too the bi-metalic affect can warp the housing at high power and
 lose sealing efficiency. Jim Mederer at RB has addressed this issue
 by grinding groves inside the water jacket to increase the heat transfer
 to the cooling fluid and decrease the tendency of the inner wall
 to warp at high temps. I would consider this essential for any high
 powered rotary engine. Most of us using rotary engines in
 aircraft have taken this modification for granted.

I've grooved a set of housings for an engine sent to an EZ builder in Germany
and then again on the engine I'm building for Tracy Crook. It's a simple job,
although very time consuming. The hardest part is making that first cut in a
new housing. Racing beat has the 3/16 diameter carbide ball cutter needed for
the job. Allot of WD40 is used in the process to keep the cutter from
clogging. Just cut shallow "crop rows" parallel to the sides of the housings,
on the combustion side, starting at the upper dowel pin hole, down to about
the 6:30 position.  Plan on wearing a dust mask along with safety glasses,
unless you like the taste of aluminum.
Bruce Turrentine

Everett Hatch had pretty good luck just "porting" out the water jacket.
Everett tried a bunch of things along the lines of improving the
heat transfer in this area. In one case he used an external water
manifold to supply cold water directly to the spark plug area.
He deemed it not worth the trouble as I recall.

Mazda merely went in there with a mill and milled some material away
from the spark plug bosses on the late turbo engines.

NC mill porting is all the rage in hot rod circles. It probably
could be applied in this situation.
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org